Shenzhen ranking of electroplating anode oxidation purified water equipment, reverse osmosis equipment and pure water equipment manufacturer

一． 设备简介

1、 Equipment introduction

镀涂装行业中，为了增加镀件表面光洁度、亮度、附着力，电镀液的配制需要用电导率在15uS/cm以下的纯水，另外在镀件漂洗时也需用电导率在10uS/cm以下纯水来清洗，电镀行业水处理系统包括电镀前电镀液配制需要的纯水处理系统、电镀漂洗废水中稀有金属回收漂洗水循环利用废水零排放系统。宏洁水务在满足用户用水标准的基础上，在设备系统中水箱均设有液位控制系统、水泵均设有压力保护装置、在线水质检测控制仪表、电气采用PLC可编程控制器，真正做到了无人职守，同时在工艺选材上采用推荐和客户要求的方法，使设备与其它同类产品相比较，具有更高的性价比和设备可靠性。

In the plating and coating industry, in order to increase the surface finish, brightness and adhesion of the plating parts, pure water with conductivity below 15US / cm is needed for the preparation of the plating solution. In addition, pure water with conductivity below 10us / cm is also needed for the rinsing of the plating parts. The water treatment system of the electroplating industry includes the pure water treatment system for the preparation of the plating solution before electroplating A zero discharge system for the recycling of rare metals in electroplating rinsing wastewater. On the basis of meeting the user's water use standard, Hongjie water has set up liquid level control system in the water tank of the equipment system, pressure protection device in the water pump, online water quality detection and control instrument, and PLC programmable controller in the electrical system, so that no one is on duty. At the same time, the method of recommendation and customer requirements is adopted in the process of material selection, so that the equipment is compared with other similar products, It has higher cost performance and equipment reliability.

二． 设计标准及依据

2、 Design standard and basis

1. 根据用户提供的详细水质报告“量身定制”。

1. According to the detailed water quality report provided by the user, "customized".

2. 水处理设备技术条件《JB/T 2932-1999》

2. Technical conditions of water treatment equipment JB / T 2932-1999

3. 反渗透水处理设备标准《CJ/T119-2000》

3. Standard for reverse osmosis water treatment equipment CJ / t119-2000

4. 低压开关设备和控制设备成套装置《IEC439-1 》

4. Complete set of low voltage switchgear and control equipment iec439-1

5. 流体输送用不锈钢焊接钢管《GB/T 12771-2008 》

5. Stainless steel welded steel pipe for fluid transportation GB / T 12771-2008

三． 工艺流程

3、 Process flow

1、 原水－原水加压泵－多介质过滤器－活性炭过滤器－软水器－精密过滤器－一级反渗透设备－纯水箱-紫外线杀菌器－用水点

1. Raw water - raw water booster pump - multi media filter - activated carbon filter - water softener - precision filter - primary reverse osmosis equipment - pure water tank - ultraviolet sterilizer - water point

2、 原水－原水加压泵－多介质过滤器－活性炭过滤器－软水器－精密过滤器－级反渗透－PH调节－中间水箱－级反渗透－纯化水箱－纯水泵－紫外线杀菌器－微孔过滤器—用水点

2. Raw water - raw water booster pump - multi media filter - activated carbon filter - water softener - precision filter - stage reverse osmosis - pH regulation - intermediate water tank - stage reverse osmosis - purified water tank - pure water pump - ultraviolet sterilizer - microporous filter - water point

四． 设计特点

4、 Design features

1. 系统采用全自动控制(同时亦可采用手动控制），系统运行时可设定自动反洗、再生程序；

1. The system adopts full automatic control (manual control is also available), and automatic backwashing and regeneration procedures can be set during system operation;

2. 各单元接线均在工厂内完成，减少安装调试时间；

2. The wiring of each unit is completed in the factory to reduce the installation and debugging time;

3. 一级反渗透和二级反渗透设有回流管道，反渗透设备设有化学清洗装置；

3. The primary RO and secondary ro are equipped with return pipes, and the RO equipment is equipped with chemical cleaning device;

4. 管道一般采用UPVC材质；

4. UPVC material is generally used for pipes;

5. 集成控制系统和集成仪表系统等，方便操作管理；

5. Integrated control system and instrument system to facilitate operation and management;

6. RO膜定时清洗 具有开机和定时清洗RO膜功能，延长RO膜使用寿命；

6. Timing cleaning of RO membrane has the function of starting up and timing cleaning of RO membrane to prolong the service life of RO membrane;

7. 水回收率 通过特殊的工艺设计，大幅提高了设备的回收率，可达70%；

7. Water recovery rate through special process design, greatly improve the recovery rate of equipment, up to 70%;

8. 设备具有耗材更换自动提示功能，并且耗材的更换周期取决于水质和压力的变化，而非根据耗材的使用时间，考虑到了各地水质的差异，设计更；

8. The equipment has the function of automatic prompt for the replacement of consumables, and the replacement cycle of consumables depends on the change of water quality and pressure, not on the use time of consumables. Considering the difference of water quality in different places, the design is more reasonable;

9. 自我保护功能 源水缺水自动停机保护功能同时具有水箱缺水自动产水、满水自动停机功能。

9. Self protection function, automatic shutdown protection function for source water shortage, and automatic shutdown function for water tank shortage and full water.